How to power 120V LED neon rope lights?

Led neon rope light 

To power LED neon rope lights, follow these steps:

1. Check the Voltage Requirement

LED neon rope lights usually come in either 12V or 24V, so make sure you know the correct voltage before proceeding. You can find this information on the packaging or product specs.

2. Choose a Suitable Power Supply

Once you know the voltage requirement, you’ll need a compatible power supply (also called a transformer or driver). The power supply should match the voltage of the rope light (e.g., 12V or 24V) and have enough wattage to handle the length of the LED neon rope you are using.

To calculate the required wattage:

• Check the power consumption per meter (or foot) of the rope lights (this is usually listed in watts).
• Multiply the wattage per meter by the total length of the rope light.

3. Connect the LED Rope Light to the Power Supply

Most LED neon rope lights come with pre-wired connectors that plug directly into the power supply. For those that don’t, you may need to strip the wires and connect them to the output terminals on the power supply.

4. Plug into an Outlet

Once everything is connected, plug the power supply into an electrical outlet. If your rope lights have a switch, turn it on to test.

5. Safety First

Make sure the power supply has overload protection and is rated for outdoor or indoor use, depending on where you plan to install the lights. Also, check if the lights are water-resistant (if using outdoors).

If you are using LED neon rope lights outdoors, you might need an IP-rated power supply to handle the weather. Always follow the manufacturer’s instructions for installation and safety.

Buy ETL Listed Led Neon Rope Lights here： https://www.shine-decor.com/collections/neon-rope-lights